Filter
Top Products
37
1. For ease of installation, extend LATCH
to its
maximum length and remove from storage bars.
2. Position base in vehicle seat as shown.
3. Make sure LATCH is through vehicle/LATCH
belt path normally used for vehicle seat belt.
.
Belt must lay flat and not be twisted.
4. Hook Connectors to vehicle lower anchors.
Pull firmly on Connectors to be sure they are
attached .
5. Tighten LATCH by pushing down hard on base
and pulling the adjustment belt .
6. NEVER put two LATCH connectors on one
vehicle LATCH anchor unless specifically allowed
by the vehicle manufacturer
.
7. Test infant restraint for secure installation as
described in infant restraint “Final Safety Check”
page 40.
8. Check that the LATCH stays tight and does not
slip from the tightened position. If it does not stay
tight, try another seating position or contact
Graco at 1-800-345-4109.
9. To remove LATCH, push button while
pulling on the LATCH belt as shown
10. Press and hold LATCH release hinge
.
11. Push connector in, lift connector up and
pull out (away from anchor point)
.
12. Repeat steps 10 and 11 for other connector.
7.3 Using LATCH to install Base