Graco 1770576 Car Seat User Manual


  Open as PDF
of 104
 
18
FORWARD-FACING INSTALLATION WITH LATCH
Adjust child restraint to Upright position
(fig. a). Flip recline feet out for
forward facing use.
-AKESURE2EAR&ACINGLATCH belt is
stored. (see fig. b, pg. 37)
Place
forward-facing ONVEHICLESEAT
EQUIPPEDWITHLATCH anchors.
For ease of installation, extend LATCH
belt to its maximum length.
(OOKCONNECTORSTOVEHICLELOWER
anchors (fig. b). Belt must lay flat and
not be twisted. Pull connectors to be
sure they are securely attached (fig. c).
3LIDECHILDRESTRAINTBACKUNTILTHE
RESTRAINTISINCONTACTWITHTHEVEHICLE
SEATBACK
1
2
3
4
5
Press down firmly in center of child restraint to
COMPRESSVEHICLESEATCUSHIONWHILETIGHTENING
LATCH belt by pulling adjustment belt (fig. d).
0ULLFRONTTOBACKANDLEFTTORIGHTATBELTPATH
TOCHECKFORSECUREINSTALLATION(fig. e).
#HECKTHATTHELOWERANCHORBELTSTAYSTIGHT
and does not slip from the tightened position.
If it does not stay tight, try another seating
POSITIONORCONTACT#USTOMER3ERVICE
6
7
!TTACHTETHERSTRAPHOOK(A) to anchor
hardware (B) and tighten adjustment belt to
REMOVEANYSLACK(fig. f).
Belt must lay flat and not be twisted.
0ERIODICALLYCHECKTHATCHILDRESTRAINTIS
SECURELYINSTALLEDADJUSTIFNECESSARY
8
4OREMOVE LATCHSEEh2EMOVINGLATCH from
6EHICLE!NCHOR0OINTSvP
 previous next