Filter
Top Products
• Combination Lap/Shoulder
Belt with Sliding Latch Plate
This belt has a latchplate t hat
slides freely along the belt.
This belt MUST be converted to prevent
movement of the lap portion of the belt. You
must use the locking clip provided with the
infant restraint, unless your vehicle's seat belt
can be converted in another way as described in
your vehicle owner's manual.
To Install Locking Clip:
1. Tighten the buckled belt by pushing down
hard on t he infant restraint and pulling
hard on t he shoulder belt.
2. While pushing down on infant restraint,
pinch the two straps together behind the
buckle tongue. Unbuckle the belt
without allowing it to slip.
3. Connect lap and shoulder belts
with locking clip as shown
➊
and ➋.
4. Rebuckle belt. Check that lap belt
does not move by pulling and
pushing hard on infant restraint.
If belt loosens or lengthens,
repeat procedure.
Locking clip
½
inch
➊
Locking clip goes here,
1
/2 inch from the buckle
➋
24