Filter
Top Products
How to properly
Assemble your gogo Kidz™ Travelmate
For the Roundabout®, Marathon™ & Decathlon™
Step 1. Lay seat face down and insert retainer bar in between seat-belt
holder of car seat.
Step 2. Align the bottom tabs with the bottom of the car seat and lay the
gogo Kidz plate on the back of the car seat.
Step 3. Insert the screws into the holes on the back of the plate and tighten.
You may need to pull up on the bar while screwing.
The gogo Kidz needs no special instructions when transporting the Britax®
seat from place to place. However, when transporting a child over 35 lbs.,
strapped in the seat, follow these instructions:
Special Instructions for transporting
your child in the gogo Kidz™ Travelmate
Step 3. Always secure your child with the safety harness provided by the car
seat manufacturer.
Step 1. Attach the gogo Kidz to the Britax car seat by following the assembly
instructions. After the gogo Kidz is attached to the Britax seat, and the
handle is in the collapsed position, pull 10 inches of the “versa-tether”
strap from the pouch that is located on the rear of the seat near the top.
Tether Pouch
Step 2. Pull the strap over the handle and tighten the “versa-tether” by
pulling on the end of the tether strap. Place excess strap back into the pouch.
Tuck in all remaining latch and tether straps in order not to get tangled when
in use.
Please follow the instructions above for complete assembly.
Special Instructions for Inserting the Retainer
Bar with the Wizard® or Boulevard™ car seat
To attach the Wizard/Boulevard Retainer Bar,
roll the cut out portion around the bar in the
back of the seat, starting from the bottom with
the cut out prtion facing the top of the seat.
The two conical sections should be facing
towards you at this point. Use the fingers of
one hand to align the conical shapes with the
holes int he main plate and thred the Thumb-
screws with the other hand.