Filter
Top Products
2
For A. D. A. compliance, top of lower double stud should be
30.5“ (78 cm) from the floor.
R
ecommended Blocking:
Wood double stud blocking is necessary. Contact an architect
and building official to make sure the blocking is adequate and
complies with building codes (Fig b).
1. Slide changer into blocking area and mark mounting hole
location on blocking studs.
HINT: This may require 2 additional people to help hold
changer in position while you are marking the locations.
2. Shim changer for a snug fit.
3. Align holes in changer with marked holes and secure using
the appropriate fasteners (Fig. c).
NOTE: It is installers responsibility to provide correct
fastereners for other substrates.
4. Ensure all six (6) fasteners are tight.
INSTALLATION - RECESSED
INSTALLATION - SURFACE-MOUNT
Recommended Blocking:
If the walls do not have studs on center, then additional blocking
is necessary (Fig. d).
Contact an architect or building contractor to make sure the
blocking is adequate and complies with building codes.
For A. D. A. compliance, measure up 50 1/4” (128 cm) from the
floor and mark the wall. This locates the position for the top
left attachment hole.
NOTE:
- Changer MUST be mounted to studs (Fig. e).
- This unit incorporates a finishing collar that seats behind
the changer’s outside flange. Center the collar as the
unit is being tightened against the wall (Fig. f).
Fig. c
Recess
Mounting
Holes
Recess
Mounting
Holes
Recess
Mounting
Holes
3
4 1/2" (876 mm)
R
ough-in
Double Stud
Double Stud
Double Stud
Double Stud
3 7/8"
(98.4 mm)
1"
(25.4 mm)
21 3/4"
(552 mm)
Rough-in
34 1/2"
(876 mm)
For A. D. A.
Compliance
30.5”
(78 cm)
T
OP
VIEW
F
RONT
VIEW
A. F. F
19.4"
(492 mm)
Fig. b
Fig. e
Surface-Mount
Holes
1
4
”
(
3
5
6
m
m
)
o
n
c
e
n
te
r
32"
(813 mm)
on center
Top
For A. D. A.
Compliance
50 1/4”
(128 cm)
A. F. F
Fig. d
Fig. f
Collar
Unit
Wall