Filter
Top Products
Battery Installation
Battery Safety
Information
• Locate the battery compartment door on
the back of the tree.
• Loosen the screws in the door with
a Phillips screwdriver and remove it.
• Insert two “AA” (LR6) alkaline batteries.
Hint: We recommend using alkaline
batteries for longer battery life.
• Replace the battery compartment door and
tighten the screws. Do not over-tighten.
• If this product begins to operate
erratically, you may need to reset the
electronics. Slide the power switch off and
back on.
• When sounds from this toy become faint
or stop, it’s time for an adult to change
the batteries.
• Protect the environment by not
disposing
of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities.
In exceptional circumstances, batteries may leak
fluids that can cause a chemical burn injury or
ruin yourproduct. To avoid battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods of non-use.
Always remove exhausted batteries from the
product. Dispose of batteries safely. Do not
dispose of this product in a fire. The batteries
inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent
type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
product before charging.
• If removable, rechargeable batteries are
used,
they are only to be charged under
adult supervision.
1,5V x 2
“AA” (LR6)
Assembly
• Fit the tabs on the ramp into the slots in the
tree base. Push to “snap” in place.