Filter
Top Products
2
Battery Installation
• Protect the environment by not disposing of this product with household waste
(2002/96/EC). Check your local authority for recycling advice and facilities
(Europe only).
Remote Controller
•
Locate the battery compartment on the bottom
of the remote controller.
• Loosen the screw in the battery compartment
door with a Phillips screwdriver. Remove the
battery compartment door and insert three
“AAA” (LR03) alkaline batteries.
• Replace the battery compartment door and
tighten the screw with a Phillips screwdriver.
Do not over-tighten.
• If this product begins to operate erratically, you may need
to reset the electronics. Remove the batteries and replace
them in the remote controller.
1,5V x 6
“AAA” (LR03)
We recommend the use of alkaline
batteries for longer battery life.
IMPORTANT! Under normal use conditions, the batteries in the vehicle will require
replacement more often than the batteries in the remote controller. For additional
information, refer to the troubleshooting section on the last page of this sheet.
Vehicle
• Loosen the screws in the bottom of
the vehicle with a Phillips screwdriver.
Lift the top of the vehicle off of
the chassis to access the battery
compartment. Insert three “AAA”
(LR03) alkaline batteries.
• Replace the top of the vehicle and
tighten the screw with a Phillips
screwdriver. Do not over-tighten.
• If this product begins to operate erratically,
you may need to reset the electronics.
Remove the batteries and replace them
in the vehicle.
• Please keep this instruction sheet for future
reference, as it contains important information.
• Requires six “AAA” (LR03) alkaline batteries
(not included) for operation.
• Adult assembly is required for battery installation.
• Tool required for battery installation: Phillips
screwdriver (not included).