Filter
Top Products
Assembly
• Lift the arch on the base and “Snap” it
into the base.
Note: The arch is connected to the base
by an electrical wire. Make sure this wire
retracts into the arch before snapping into
the base.
1
2
1
1
• “Snap” the treetop to the tree trunk and
then into base.
Note: The treetop only fits onto the tree
trunk one way. If it does not seem to fit,
turn it around and try again.
• “Snap” the tree trunk into the base.
1
3
• “Snap” the hedges into the slots in
the base.
Note: If a hedge does not seem to fit into a
slot, try the other slot.
1
4
• Insert the tree branch into the arch and
the base.
• Push down on the tree branch to “snap”
it in place.
3
Arch
Base
Treetop
Tree Trunk
Hedges
Tree Branch