Filter
Top Products
Assembled Parts
Both Shown Actual Size
Note: Tighten and loosen all screws with a Phillips
screwdriver. Do not over-tighten the screws.
• Fit the front brace onto one of the frames.
Hint: The front brace will only fit on the frame one way. If it does
not seem to fit, turn it around and try again!
• Insert two M3.5 x 15mm screws into the holes in the frame
and tighten.
• Fit the other frame onto the braces.
• Insert three M3.5 x 15mm screws into the holes in the frame
and tighten.
IMPORTANT! This step must be completed before attaching
the seat to the frame assembly.
• "Snap" the support bar onto the pegs on the top of the
frame assembly.
This package contains small parts in its
unassembled state. Adult assembly is required.
Take extra care during unpacking and assembly.
CAUTION
• Fit the back brace onto the same frame.
Hint: The back brace will only fit on the frame one way. If it does
not seem to fit, turn it around and try again!
•
Insert an M3.5 x 15mm screw into the hole in the frame and tighten.
1
2
1
3
4
Seat
Back BraceFront Brace
Support Bar
Tray
2 Frames
Front Brace
Frame
Back Brace
Frame
Support Bar
Frame Assembly
Assembly
• Fit the seat onto the frame assembly. Push down on the seat to
fit in place.
1
7
Frame
Assembly
Seat
• "Snap" the tray handles into the holes in the seat.
1
5
Tray
• While holding the seat in place, turn the assembly face down.
• Insert two M4.5 x 18mm washer head screws into the holes in the
back of the seat, as shown.
• Tighten the screws.
1
8
• Insert two M4.5 x 18mm washer head screws into the holes on
the bottom of the seat, as shown.
• Tighten the screws.
1
9
• "Snap" the bear toy into the slot in the seat.
1
10
M3.5 x 15mm Screw - 8 M4.5 x 18mm
Washer Head Screw - 4
Seat
BACK VIEW
BOTTOM VIEW
• Turn the seat face down. Insert two M3.5 x 15mm screws into the
seat and tighten.
1
6