Filter
Top Products
3
IMPORTANT! Before assembly and each use, inspect this product
for damaged hardware, loose joints, missing parts or sharp edges.
DO NOT use if any parts are missing or broken. Contact Mattel
for replacement parts and instructions if needed. Never
substitute parts.
Left Base Wire
• Place the base tube on a flat surface.
• Position the left and right base wires as shown.
• Fit the left base wire and right base wire into the base tube.
Right Base Wire
Base Tube
1
• Position the feet so the holes are toward you and the non-skid
surface is down.
• Fit the feet on the base tube, as shown.
Feet Holes
2
• Insert an M5 x 20 mm screw through each foot and tighten.
3
• Position the footrest so that the soothing unit is upright.
• Fit the footrest onto the ends of the base wires.
4
Footrest
Base Wires
Assembly