7
Assembly
11
• Position a handle so that the curved edge is down.
• Fit a handle to the upper end of two legs, as shown.
• Insert an M6 x 40 mm screw into the hole in the top of each leg.
Tighten each screw with the Allen wrench.
• Repeat this procedure to assemble the other handle to
the assembly.
Handle
Hole
Hole
12
• Locate the ring on one side of the bassinet.
• While pressing the button on the end of the lower canopy tube,
insert it into the ring on the bassinet
A
.
Hint: If the lower canopy tube does not seem to fit into the ring,
turn it over and try again!
• Insert the end of the lower canopy tube into the socket in the
bassinet
B
. Push the tube until you hear a "click". Pull up on
the tube to be sure it is secure.
Lower Canopy Tube
Ring
Socket
A
B
Socket
PRESS
PRESS
Ring