Filter
Top Products
1
3
• Insert the tabs on the bottom of the elevator into the slots in
the base.
Push to • "snap" in place.
Assembly
2
• Insert the tabs on the pump into the slots in the base.
Push to • "snap" in place
3
4
• "Snap" the tabs on the post onto the base.
• Set the assembly on its side, and locate the tabs on the base.
• Fit a column onto one of the tabs. While holding the column
in place, insert a screw into the hole in the tab and tighten.
• Repeat this procedure to attach the other column.
• Set the assembly upright.
Post
Columns
Elevator
Base
Pump