Filter
Top Products
Assembly
1
• Turn the table top left, towards the seat back, as far as it will go.
Hint: You may need to hold the table top in this position for
the next two assembly steps (10 and 11).
1
• Locate the connector coming from the table base.
• Insert and “snap” the connector into the socket on the underside
of the table top.
• Tuck the excess wire from the connector back down into the
opening in the table base.
Socket
Connector
Back View
8
9
Table Top
1
• Fit the plastic connector to the back of the table and in front of
the seat back.
Note: Make sure the plastic connector is in front of the seat back.
10
Plastic
Connector
1
• Align the holes in the plastic connector with the holes in the
table. Insert two screws into the plastic connector and tighten.
Assembly is now complete.
11
Table
Seat Back