Filter
Top Products
3
1,5V x 4
“D” (LR20)
Battery Installation
• Loosen the screws in the battery compartment door and remove
the battery compartment door.
• Insert four “D” (LR20) alkaline batteries into the battery compartment.
• Replace the battery compartment door and tighten the screws.
• Low battery power may cause this product to operate erratically
(no movement/no sounds) and the product may not turn off. If this
should happen, remove and discard all batteries and replace with
four, new “D” (LR20) alkaline batteries.
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that
can cause a chemical burn injury or ruin your product.
To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types:
alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove
exhausted batteries from the product. Dispose of batteries safely.
Do not dispose of this product in a fire. The batteries inside may
explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removeable, rechargeable batteries are used, they are only to be
charged under adult supervision.
Assembly
Protect the environment by not disposing of this product with
household waste (2002/96/EC). Check your local authority for
recycling advice and facilities (Europe only).
• Lift both base tubes.
1
Base Tubes
IMPORTANT! Before assembly and each use, inspect this product
for damaged hardware, loose joints, missing parts or sharp edges.
DO NOT use if any parts are missing or broken. Contact Mattel for
replacement parts and instructions if needed. Never substitute parts.
Base
Lift
Lift
2
Hubs
• Position the hubs with the smooth side out.
• Fit the hubs onto the base tubes.
Hint: The hubs are designed to fit the base tubes one way. If the
hubs do not fit on the base tubes, check to be sure the smooth side
is out.
• Push the hubs down until you hear a “click”.
• Pull up on the hubs to be sure each is secure.
Base Tubes
Base Tubes
Hint: We recommend using alkaline batteries for
longer battery life.