Filter
Top Products
Assembly
• Locate the connector coming from underside of the chair bottom.
• Insert the connector into the socket on the table base, as shown.
• Press down firmly to “snap” the table top onto the table base.
Note: This may require some force.
1
• Fit the connector cover onto the back of the table base,
as shown.
• Insert two screws into connector cover. Tighten the screws.
• Insert two screws through the table base into the leg. Tighten
the screws.
1
• Locate the connector coming from the table base.
• Insert and
“snap” the connector into the socket on the underside
of the table top.
• Tuck the excess wire from the connector back down into the
opening in the table base.
Assembly is now complete.
Table Top
Connector
• Slide the table base onto the chair assembly, as shown.
Table Base
Socket
Connector Cover
Connector
Back View
Back View
4
5
1
6
7
8
9