Filter
Top Products
12
12
Setup and Use
1
Waist Belts
Crotch Belt
• Place your child in the seat. Position the crotch belt between
your child’s legs.
• Fasten the waist belts to the crotch belt. Make sure you
hear a “click” on both sides.
• Check to be sure the restraint system is securely attached by
pulling it away from your child. The restraint system should
remain attached.
3
• Make sure your child is properly secured in the seat.
• Slide the swing power switch on to any of six speed settings.
The power indicator lights.
• Give the seat a light push to begin swinging.
• Watch the bird “fly” when the seat swings!
• Be sure to slide the switch to the off position when the swing
is not in use.
Hint: As with most battery-powered swings, a heavier child will reduce
the amount of swinging motion on all settings. In most cases, the low
setting works best for a smaller child while the high setting works best
for a larger child.
Note: Low battery power may cause product movement to
slow or turn off all together. If this should happen, please
remove and discard all four batteries and replace with four,
new “D” (LR6) alkaline batteries.
2
To tighten the waist belts:
• Feed the anchored end of the waist belt up through the buckle
to form a loop Ạ. Pull the free end of the waist belt ạ.
To loosen the waist belts:
• Feed the free end of the waist belt up through the buckle to
form a loop Ạ. Enlarge the loop by pulling on the end of the
loop toward the buckle. Pull the anchored end of the waist belt
to shorten the free end of the waist belt ạ.
Free End
Free End
Anchored End
Anchored End
TIGHTEN
LOOSEN
Power Indicator
Power Switch
Securing your Infant Swinging