Filter
Top Products
Assembly
4
• Fit the base wires into the slots in the retainers on the liner.
Push the retainers down.
Base Wires
Retainers
5
6
#8 x 2.22 cm Screw – 2
Retainer Lower Hole
• Insert a #8 x 2.22 cm screw through the lower hole in each
retainer and the hole in each base wire. Tighten the screws.
• Pull up on the retainers to be sure they are secured to the left
and right base wires.
7
Footrest Wire/
Seat Back Tube
Groove
•Fit the footrest wire/seat back tube into the groove in
the retainer.
Footrest Wire/
Seat Back Tube
8
#6 x 2.86 cm
Red Shoulder Screw – 2
• Insert a #6 x 2.86 cm red shoulder screw through the seatback
tube, footrest wire and into the retainer. Tighten the screw.
Hint: You may find it easier to tip the assembly on its side to insert
and tighten the screw.
• Repeat this assembly step to secure the other end of the footrest
wire/seat back tube to the other retainer.
• Push down on the seat portion of the liner to be sure it is secure
to the retainers.