Filter
Top Products
15
Calibrating the Stylus
• Turn Pixter® over and locate the calibration hole.
• Insert, push and hold the stylus in the calibration hole.Turn Pixter over
so that you can see the screen.When you see two , you can remove
the stylus from the calibration hole.
• First touch the upper left corner with the tip of the stylus.
• Then, touch the lower right corner with the tip of the stylus.
Hint: After calibrating your screen, the contrast resets to the mid-level.
To change the contrast on the screen, touch the Save It! tool.
™
IMPORTANT!
From time to time, the mark made
on your screen from the stylus and
the location of the tip of the stylus
may not align. When this happens,
you must calibrate the stylus.
Mark on Screen
Tip of
Stylus
Calibration
Hole