Filter
Top Products
Assembly
5
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Repeat assembly steps 3 - 5 to attach the other ends of the
frame tubes to the frame on the other side of the base.
5
• Position the base wires around the base so that the ends
point upward and are against the lower holes in a frame.
• Place a spring onto an M6 x 1
5
/
8
" screw.
• Insert the M6 x 1
5
/
8
" screw with spring through a base wire
and into the frame.
Base Wire
Lower Hole
Spring
Frame
Base
Wire
M6 x 1
5
/
8
" Screw - 4
Spring - 4
6
• Fit an M6 lock nut (with the
rounded side toward the
fabric) into each lower,hexag-
onal opening on the back
of the frame.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Repeat this procedure to attach the other ends of the
base wires to the frame on the other side of the base.
Frame
7
Rounded Side
M6 Lock Nut - 4