Filter
Top Products
14
• Align the tips of the screws with the holes in the other
half of the sport bar cover and fit the two sport bar cover
halves together.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
Half of
Sport Bar
Cover
(RON)
Screw Tips
Sport-Bar
20
• Snap the gas cap assembly into the square opening in
the rear of the vehicle. (The gas cap tether should point
down.)
Gas Cap
Assembly
Tether
22
• With the sport bar positioned to angle towards the rear of
the vehicle, fit the ends of the sport bar in the holes in
the vehicle body on either side of the seat.
• Press firmly on each side of the sport bar to snap it into
the vehicle body.
Sport Bar
Rear of
Vehicle
Seat
Hole
Hole
• Fit a taillight lens in a taillight housing.
Taillight Lens
Taillight
Housing
23
• Face the back of the vehicle.
• Align the holes in the taillight lens and housing assembly
with the holes in the vehicle body.
• Insert two #8 x 1” screws through the holes in the taillight
assembly and into the vehicle body.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Repeat steps 23 and 24 to assemble the other taillight
lens and taillight housing to the vehicle body.
Taillight Lens and
Housing Assembly
Rear of
Vehicle
Body
24
21
Assembly