Filter
Top Products
Place child restraint rear-
facing in the back seat.
With child restraint in the
most reclined position,
make sure level lines on
shoulder belt guide are
level with ground. Adjust
child restraint if needed.
NOTE: Do not use the
top anchorage strap
(tether) in the rear-facing
position.The top anchorage strap and hook should be
placed under the child restraint.
28
To use the child restraint
rear-facing, make sure
recline stand is folded
under seat.
A loose top anchorage (tether) strap can
result in serious injury or death.
A loose LATCH system can result in
serious injury or death.
After deciding whether to use your Vehicle Belts or
LATCH, be sure to read the warnings below as they
pertain to both systems.
Rear-Facing Installation
When LATCH is not
available, fasten belt hooks
on side of child restraint as
shown.
WARNING:
!
Rear-Facing Use: 5-35 lbs. (2.3-16 kg), 19-36” (48-91 cm)
Rear-Facing Installation with
Vehicle Belt:
Thread the vehicle lap or
lap/shoulder belt
combination through the
rear-facing belt slot.
2
LEVEL
TO GROUND
1
Thread UNDER seat pad
in front of the buckle
strap and out opposite
side. Buckle vehicle belt.
Do not place vehicle
belt over child’s legs.
NOTE: The crotch strap
must be in the 1st and
2nd crotch strap slots (see “Preparing Child Restraint
to Fit Your Child” section). The 3rd slot is for
forward-facing only.
3
29
continued on next page.
4358-3432E Enspira 5pt 8/6/07 4:46 PM Page 31