Filter
Top Products
28
29
Rear Facing Use: 5-35 lbs. (2.3-16 kg), 19-36” (48-91 cm).
Connect and tighten
harness straps prior to
installing in vehicle.
Place child restraint rear-
facing in the back seat. With
child restraint in the most
reclined position, make sure
level lines on shoulder belt
positioning guide are level
with ground. Adjust child restraint if needed.
NOTE: Tuck top anchorage strap and hook under the
base or child restraint.
4
Push LATCH hook
through the rear-facing
belt path slot.
Push LATCH hook
through the other rear-
facing belt path slot.
6
Put seat pad back over
corners of shell.
Completed threading of
the LATCH system rear-
facing is shown.
7
Fasten one LATCH belt
hook to the anchor in the
vehicle seat located in the
vehicle seat bight. Repeat
for other side of child
restraint. See your vehicle
owner’s manual for more
information.
Push down firmly on the
child restraint and pull up
on the loop to tighten belt.
Rear-Facing Installation with
LATCH: Install in Vehicle
2
3
continued on next page.
Pull other end of LATCH
hook under pad in front
of crotch strap to the
opposite side.
Do not place LATCH
belt over child’s legs.
5
NOTE: In some cases, you
may need to pull the pad
off the front corner and
expose the belt path.
Tighten belt through belt
path slot. Replace pad on
corner.
LEVEL
TO GROUND
1
4358-3340D Elite_Lux 3/13/06 3:08 PM Page 31