Filter
Top Products
assembly instructions
IMPORTANT
Prior to patient use, be sure to tighten
trapeze clamps onto either bed or Trapeze
base.
1. Connect sections 1 & 3 by sliding section
3 over section 1 and depressing push pins
to secure in place. Repeat for section 2.
2. Connect sections 3 & 4 by sliding section
4 down over section 3. Pull locking pin (A)
outward to allow section 4 to lock into
position.
3. Slide ring (B) over the tube of section 4
by depressing push button on section 4
and sliding into place. Insert thumb
screw (C) through ring (B) and turn
clockwise until tight to secure in place.
NOTE: thumb screw should be inserted
into the side of B without the receptacle
nut to be sure it locks into place correctly.
Section 4
Section 3
Section 2
Section 1
(A)
(B)
(C)
The Trapeze , used in conjunction with a bed,
can assist an individual weighing up to 650lbs
(295kg). The Trapeze is designed to provide
support, increase stability and assist the user
when repositioning himself/herself in bed.
The Trapeze is not designed, however, to sup-
port the total body weight of an individual.
Use it for assistance only.