Dixon 3O4 Car Seat User Manual


  Open as PDF
of 6
 
REMOVING THE MOWER BLADE
Secure blade (P/N 2483) from turning. Remove blade bolt from center
(P/N 3268) and blade washer (P/N 6260), then blade (P/N 2483). To reinstall,
reverse above procedure.
WARNING: Sharp edges on blade can cause injury!
Caution should be exercised when service is required on blade.
REMOVING MOWER DECK
1. Loosen the belt keeper (P/N 7026 & 7027), located under the engine, by
loosing two rear engine mounting bolt's, allowing the deck drive belt to cone
free of the rear pulley.
2. Disconnect the wiring loom at the deck safety switch (P/N 4242).
3. Remove the two clevis pins (P/N 3072) from the two rear L-rods (P/N 1355) and
slide from slots.
4. Remove clevis pins (P/N 3072) L-rod attached to lift handle and slide from slot.
5. Remove clevis pin (P/N 3072) from front deck hanger shaft (P/N 1332), located at
from of mower deck on slide plates welded at battery box and remove.
6. Lift front of mower chassis and roll free of the deck.
7. To install, reverse the above procedure.
MOWER BLADE OPERATION
To engage the mower blades, turn lever on floor slowly to the "ON" position. To
disengage mower blades, turn lever slowly to the "OFF" position.
"IMPORTANT" - PERFORM SAFETY CHECKS AFTER MAKING ANY REPAIRS OR ADJUSTMENTS
1. After reassembly, while seated on mower, attempt to start engine with sower
deck engaged. Engine should not start. If engine does start, return the mower to
an Authorized Dixon Dealer for adjustment or repair.
2. Disengage mower deck and start engine. With the operator in the normal
seated position, engage mower deck and remove weight from seat. The engine should
stop. If the engine does not stop when operator rises from seat, return the mower
to an Authorized Dixon Dealer for adjustment or repair.
3. Engage, then disengage, mower blade in each cutting height. Insure that blade
disengages and comes to a stop within (5) seconds in each height position.
If blade does not disengage properly, contact your Authorized Dixon Dealer.
PARKING BRAKE ADJUSTMENT
1. Raise upper body to the open position.
2. Tighten nut on brake rod (P/N 2533) located in front of the transaxle on
each side, just enough to prevent brake from slipping when engaged. :
CAUTION: Over tightening may cause premature wear on the brake band (P/N
5085).
Page 2 of 7
Revised 1/92
(P/N 8112)
 previous next