Filter
Top Products
2-18 Dell PowerVault 720N, 740N, and 760N Installation and Troubleshooting Guide
+
!,)'"#
At this point, the filer, PowerVault 700N storage system, and tape backup device are
connected and the filer is connected to the network.
You are ready to power on the system. Before you do so, it is a good idea to establish
a terminal connection to the filer so that you can observe the system responses on
the terminal screen when the system is started. You also need a terminal to set up
the filer after you start it.
'!'))
You can establish a connection to the filer from an ASCII terminal, serial concentrator,
or communications server.
This section describes how to connect an ASCII terminal (also referred to as an
ANSI
terminal
) to the filer and how to verify the filer and PowerVault 700N storage system
installations.
,+
A DB-9–to–DB-9 straight-through serial cable for an ASCII terminal connection is pro-
vided with your filer. If this cable is not compatible with your terminal connector, use a
null modem cable.
The filer’s DB-9 serial port supports only DTE devices, not DCE devices such as
modems. Most terminals are wired as DTE devices.
NOTE: To use a serial concentrator or communications server, refer to the documenta-
tion for those devices.
33!#
The following table lists the pin settings for the DB-9 CONSOLE port.
. &-
$,1 $,1
1 Data Carrier Detect 5 Ground
2 Receive Data 6 Data Set Ready
3 Transmit Data 7 Request to Send
4 Data Transmit Ready 8 Clear to Send