Filter
Top Products
"CLICK"
When installing the base, ensure the bottom
of the base is in contact with the vehicle
seat.
NOTE: See additional information on page
33 about putting extra support under the
front of the base.
27Section 8 - Installing the Car Seat Base with LATCH 28Section 8 - Installing the Car Seat Base with LATCH
Check that the base is securely held.
If the base moves easily more than 1"
(25mm) to either side, try another position, or
do not use the car seat in the vehicle.
To remove the carseat from the base, pull
firmly upwards on the release lever at the rear
of the car seat, and lift the carseat upwards.
WARNING: DO NOT use the car seat if it
is not securely connected to the base.
FITTING THE CAR SEAT INTO THE BASE.
Before putting the car seat into the base
make sure there are no objects on or in the
base.
Connect the car seat to the base.
NOTE: listen for a "CLICK" when the car seat
is installed into the base, and lift the car seat
to ensure the car seat is fully conected to the
base.