Combi 9100-0 Bouncy Seat User Manual


 
COMBI International Corporation • 199 Easy St. • Carol Stream, IL 60188 • www.combi-intl.com
Customer Service 1-800-992-6624 • 10:00 a.m. - 5:00 p.m. Central Time • Monday - Friday
- 2 -
Attaching the Canopy
1. To install the canopy place the notch in the clamp of the
canopy holder into the hole on the frame. (Located above the
waist belt).
2. Open the canopy by pulling on the visor with one hand until
fully opened.
3. Before folding the Melody Bouncer, grasp the visor and push
down to close the canopy.
Using and Adjusting the Seat Belt
Never the lift Melody Bouncer using the toy bar.
WARNINGS
Place the crotch belt between babys legs and
fasten the waist belt buckles together.
After adjusting the waist belt, make sure it is
fastened securely.
To adjust the waist belt,
loosen the slack on both
sides of each buckle.
CAUTION
Even when the seat belt is
fastened, be careful not to
let the child slip out or
stand.
WARNING
Avoid serious injury from falling or sliding out.
Always use seat belt.
Canopy
Holder
Clamp
Frame
To remove the
Canopy
Grasp the
canopy holders
on each side,
one at a time,
and pull out from
the frame.
Installing the Toy Bar
To install the toy bar, place the notch in the clamp of the toy bar holder into
the hole on the front tube (located above the seat).
Toy bar
Toy bar
holder
Clamp
Frame
Seat cushion
WARNING
Never lift the Melody Bouncer using the toy bar.
Note:
Clamp must be positioned behind the toy bar holder in order
to insert into the front tube.