Filter
Top Products
13
Installing and Removing Seat Back:
To install seat back:
• Place Booster Car Seat base on floor or firm surface.
• Holding seat back slightly reclined, place tabs at bottom of seat back
into slots of seat base (fig. a).
• Rotate seat back upright .
• Press down firmly until wings on side of seat back touch arms
on seat base .
To remove seat back:
• Place High Back Booster Car Seat on the floor or other firm surface.
•While holding the base down, pull the seat back straight up until it stops,
then rotate seat back into a reclined position and lift out.
(fig. a)
Section 9 - Seat Back Assembly
Base
Seat
Back
Wings
2
2
3
Top Of
Arms
3
1
1
14
This child restraint system conforms to all applicable Federal Motor Vehicle Safety Standards for use in motor
vehicles.
Certification
Car seat parts can get very hot in the sun or warm weather.
To avoid burns, always check before putting child in car seat.
Warm Weather
This restraint (Booster Car Seat) is NOT certified for aircraft use (see label on car seat).
An aircraft does not have lap and shoulder belt systems required to use with Booster Car Seats.
Aircraft Use
DO NOT use after 7 years from date of manufacture on label.
Car Seat Useful Life
Protect vehicle seat. Use a thin car seat mat, thin towel, or thin blanket under and behind car seat.
Vehicle Seat Protection
Store instruction manual under seat pad.
Instruction Manual Storage
Section 10 - Additional Information