Filter
Top Products
Trade name and trademarks of Graco
®
, Century
®
, Evenflo
®
and Cosco
®
and Baby Trends are the property of their respective owners and
no endorsement of or approval by them is intended or implied. All Combi
®
Perfect Match
™
strollers are compatible with specified models
of the Graco
®
, Century
®
, and Evenflo
®
infant car seat/carrier models and the Cosco
®
Eddie Bauer as of the date this printing was pre-
pared.
Copyright May 2004 Combi USA Inc.
- 12 -
Using the Perfect Match
™
Guardrail
1. Remove standard guardrail and attach Perfect
Match
™
Guardrail by slipping it over the armrest pins
until you hear the pins click into position.
Keep Positioning Rings toward
the ends of the guardrail.
2. Recline the backrest to the middle position. Pull the
Carrier Attachment Straps from behind the seat cush
-
ion and lay them over the armrests.
Note: When using the Evenflo
® infant car seat/carrier it
may be necessary to leave the backrest in the upright
position to provide the proper recline angle on the
infant seat/carrier.
3. Hook carrier over the Perfect Match™ Guardrail and
rotate until the foot end of infant car seat/carrier is
solidly against the backrest of stroller.
Push the positioning rings snuggly against each side of
the car seat/carrier.
4. Bring the Carrier Attachment Straps through the slots
in the infant car seat/carrier and fasten the buckle. (If
the strap is the incorrect length, adjust as needed. To
adjust, thread fabric through each side of the buckle.
1. Remove the infant car seat/carrier by reversing the
above steps.
2. Squeeze the guardrail release buttons on both sides and
lift up to release the guardrail.
CAUTION
Pull on each side of Perfect Match
™
Guardrail to make sure that it is com
-
pletely attached.
ATTACHING THE PERFECT MATCH
™
GUARDRAIL
REMOVING THE PERFECT MATCH™ GUARDRAIL
Positioning
Rings