Filter
Top Products
COMBI International Corporation • 189-199 Easy St. • Carol Stream, IL 60188 • www.combi-intl.com
Customer Service 1-800-992-6624 • 10:00 a.m. - 5:00 p.m. Central Standard Time • Monday - Friday
- 3 -
Attaching the Canopy
Attaching the Canopy
1. Confirm the canopy is facing in the proper direction.
2. Fully insert the canopy holder (male) to the canopy holder
(female) until a click is heard.
3. Fasten the canopy velcro on both sides around the handles to the
seat back velcro (2 places.)
Removing the Canopy
Pull the velcro apart and squeeze the bottom of the canopy holder
(male). Lift the canopy until it releases from the female holder.
CAUTION
Failure to fully secure the canopy holders can cause the holders to bend.
When storing the stroller by laying it down, be sure the canopy is off the
ground to prevent it from bending.
Opening the Stroller
2. Grip the handle on each side
and turn outward to open fully.
3. Lift up the handle and snap the
stroller away from you.
Holding the
handle from
underneath will
make it easier.
Lift up
Snap
away
Auto
folding
latch
Attaching & Removing the Front Swivel Wheels
Removing the Swivel
Wheels
Press in the square button
located at the bottom of the
wheel holder while pulling the
assembly off of the swivel
shaft.
Place front swivel wheel
assembly on the swivel shaft.
The assembly is secure when
it locks onto the shaft.
Release Button
Attaching the Rear Wheels
1. Stand behind the stroller.
2. Locate the small opening on each
rear wheel assembly.
3. Locate the small silver pin on each
rear stroller leg.
4. Insert the leg into the wheel assem-
bly until the small silver pin locks
into the opening.
Note:
Attach the rear wheel assemblies to each
stroller leg with the wheel spacer facing
inward.