Filter
Top Products
- 3 -
Attaching the Canopy
Attaching the Canopy
1. Confirm the canopy is facing in the proper direction.
2. Fully insert the canopy holder (male) to the canopy holder
(female) until a click is heard.
3. Fasten the canopy Velcro on both sides around the handles
to the seat back Velcro (2 places.)
Removing the Canopy
Pull the Velcro apart and squeeze the bottom of the canopy
holder (male). Lift the canopy until it releases from the female
holder.
CAUTION
Failure to fully secure the canopy holders can cause the holders to
bend. When storing the stroller by laying it down, be sure the cano-
py is off the ground to prevent it from bending.
Opening the Stroller
2. Grip the handle on each side
and turn outward to open fully.
3. Lift up the handle and snap
the stroller away from you.
Holding the
handle from
underneath will
make it easier.
Lift up
Snap
away
Auto
folding
latch
Attaching & Removing the Front Swivel Wheels
Place front swivel wheel
assembly on the swivel
shaft. The assembly is
secure when it locks onto
the shaft.
Removing the Swivel Wheels
Press in the square button located
at the bottom of the wheel holder
while pulling the assembly off of
the swivel shaft.
Release Button
Attaching the Rear Wheels
1. Stand behind the stroller.
2. Locate the small chrome pin on
each rear stroller leg.
3.
Locate the small opening on
each rear wheel assembly.
4. Insert the leg into the wheel
assembly until the small silver
pin locks into the opening.
Note:
Attach the rear wheel assemblies to
each stroller leg with the wheel spacer
facing inward.