Filter
Top Products
Page 14
The Big Caboose Stand-On Triple Instruction Manual
Figure 26
Folding the Stroller
• Keep children away from stroller
while folding.
• Remove any infant carrier that has
been installed on the stroller. Note
that the stroller can still be folded
with a car seat carrier support in
place.
• Position the stroller with the handle
bar closest to you.
• Place each canopy into its closed
position and push it all the way
forward toward the front of the
stroller as far as it will go.
• Make sure both rear wheel brakes
are set to their locked positions.
• Lock both front wheels in place with
the locking levers facing forward.
• To fold, unlatch the safety latch on
EACH side of the stroller.
• Pull upward on the trigger
mechanisms on both sides of the
stroller. See Figure 26.
• While these mechanisms are in the
upward position, push forward on
the stroller using the handle bar.
• Once the stroller begins to fold, push
the handle all the way forward and
down until the stroller is completely
folded. See Figure 27.
Figure 27
IMPORTANT NOTE
When using your stroller as an infant car seat carrier, the following
are the compatible infant car seat models that the Caboose Stand-On
Tandem will accommodate:
• Graco® Snug Rider™ Series
• Graco® SafeSeat™
• Peg Perego® Primo Viaggio
• Peg Perego® Primo Viaggio SIP
• Evenfl o® Embrace™
• Chicco® Key Fit Car Seat
• Britax® Companion™
For the most updated list of compatible infant car seats, please
either check our website at www.joovy.com or call our Customer
Service Department at (877) 456-5049.
• Combi® Centre Series
• Combi® Connection
• Safety 1st® Designer 22™
• Eddie Bauer® Infant Car Seat
(models 22-625 and 22-626)
• Baby Trend® Latch-Loc and Flex-Loc
• Compass® Light and Portable Infant Car Seat