Filter
Top Products
6
1.1.2.2 Assembling and folding the compartment following initial operation
For assembling and folding the "Captain XL" in the same way as with the Cabriolet, Corsaire XL and Comfort,
see sections 1.1.1 and 1.3.1
1.1.3 Assembling the passenger compartment of the Cheetah, Cougar and CX
Assembling the base: Push the hollow axle with your left hand downwards, and at
the same time push the left frame tube upwards using your right hand. Then pull
the short curved tube backwards with your left hand, pressing against it from
above with your right hand. Repeat this on the right hand side. When pulling the
short, curved frame tube backwards, the auto-lock must noticeably engage.
Auto-lock with release disks
1.1.4 Wheel assembly (plastic wheels) on the Cabriolet and Comfort
Put the passenger compartment on its
side. Insert clevis axle into the opening
of the hollow axle.
Push the wheel axle in as far as it will
go. As you do this, the securing peg of
the hollow axle must audibly engage in
the axle groove of the wheel. Check that
the wheel cannot be pulled off!
Removing the wheel: With one hand
pull the securing peg outwards, with
the other pull the wheel out of the
hollow axle.
Final steps in assembly:
Pull tight the looped strap. Pull the 4 rear seat strap-fasteners
tight.
The "Captain XL" is now ready for sale, and from now on, any further folding or opening of the bicycle trailer will not ent-
ail reversal of the above steps.
At the clamp, pull tight the strap hol-
ding the tops of both side walls toget-
her, at the same time as applying pres-
sure with the other hand from the out-
side.