Filter
Top Products
Re-buckle seat belt.
Test installation to see if car seat is secure. If
not secure, additional belt tightening may be
required.
Remove locking clip and repeat steps 1
through 5.
HINT: Tighten vehicle seat belt by pressing
base or car seat further down into vehicle seat
cushion.
You MUST use locking clip provided with
car seat with a vehicle seat belt that slides
freely through the latch plate or the lap belt
cannot be tightly secured.
Install car seat and tighten vehicle seat belt.
Hold seat belts together at latch plate (fig. a)
then unbuckle.
Slide locking clip on seat belts approximately
1/2 inch (1 cm) away from latch plate.
1
2
3
4
1/2 inch (1 cm)
Avoid serious injury or death:
• Failure to use locking clip where
required will result in car seat not
being securely held in place.
• Remove locking clip from seat belts
when not being used with car seat.
WARNING
5
❃
Locking Clip
(fig. a)
19