Filter
Top Products
8
FOLDING and STORING
1 To remove floorboard:
• Unfasten attachment straps.
• Remove floorboard and set
aside.
2 To unlock and raise floor:
• Push down on center of
Playard/Crib floor.
• Lift Floor Handle and
rotate in direction of
arrow (counterclockwise).
• Pull up on Floor Handle
to raise floor.
Raise approximately
45.7 cm
(18 inches).
3 To fold top rails:
• Pull up on top rail slightly.
• Squeeze Release Button
on bottom of top rail and
push rail down. (Release
buttons are identified by
printed arrows.)
Repeat for other sides.
NOTE:
• If rails are difficult to
unlock, raise center of
floor higher and
squeeze Release
Button again.
• If only one side of rail
folds, squeeze Release
Button again to fully
fold.
Playard/Crib
Release
Button
Floor
Handle
4 Gather Playard/Crib frame together
while pulling up on Floor Loop.
5 Wrap floorboard around
Playard/Crib frame with
padding facing in.
6 Secure Attachment Straps:
• Bottom - Thread Attachment
Strap through Leg Loop then
through Floorboard Loop
and fold back onto itself.
• Middle and Top - Thread
Attachment Straps
through remaining
floorboard loops
and fold back onto
themselves.
7 Stand Playard/Crib on end
and pull travel bag over
Playard/Crib.
Be sure Handle comes
through Opening in bag.
Turn over Playard/Crib and
zip bag closed.
Attachment
Straps
Handle
Opening
Floor Loop
Leg Loop
Floorboard Loop
Handle