Filter
Top Products
HARNESS SYSTEM - removal and re-assembly
16
Removal:
Harness with Breast Plates:
• Remove harness strap loops from Splitter
Plates on back and bottom of car seat.
• Pull harness strap out of car seat.
NOTE: It is not necessary to remove
harness tie and tongues from harness
straps.
Store all parts for future use.
• Remove buckle (see page 15).
Harness without Breast Plates:
• Remove harness strap loops from Splitter
Plate on back of car seat.
• Pull harness strap out of car seat, harness
tie, and tongues.
Store all parts for future use.
• Remove buckle (see page 15).
Re-assembly:
When re-assembling harness system, be sure
harness straps are not twisted.
Harness with Breast Plates:
Thread Splitter Plate and looped end of harness
straps down through slots in seat pad and
car seat then connect harness strap loop to
bottom Splitter Plate.
Harness without Breast Plates:
Thread end of harness strap down through slot
in seat pad and car seat and back up through
slot in opposite side of car seat pad, through
harness tongues and harness tie.
IMPORTANT: Harness strap MUST be threaded
over adjustment strap on bottom of car seat as
shown in illustrations.
Thread ends of harness straps through matching
shoulder slots in back of seat pad and car seat.
Re-attach harness straps to Splitter Plate on back:
Put right strap loop on Splitter Plate first, then
attach left strap loop.
Re-attach buckle (see page 15).
1
3
4
5
2