Filter
Top Products
4 Push Triangular Tabs into
TriangularHoles in Playard
corners.
5 Secure changer to Playard:
• Pass Attachment Strap
through opening in corner
of side panel of Playard.
• Fasten strap to outside of
Playard.
Repeat for other strap.
6 Place storage pocket flap over
side of Playard.
NOTE: DO NOT place supplies
weighing more than 2.3 kg
(5 lbs.) in storage pocket.
Changer is now ready for use.
ASSEMBLY and USE continued
6
1 Lay changer on flat surface.
2 Grasp middle of each long side
and gently pull apart until short
sides “click” and lock in place.
NOTE: Make sure changer sides
are fully extended and locked.
3 With vinyl side facing up,
insert two (2) “T-Fittings”
on changer into “T-Slots”
in bassinet and push down
to secure.
Changer
WARNING
Avoid serious injury or death:
• Always use restraint belt to prevent falls.
• Use with infant who weighs less than 8.2 kg
(18 lbs.) and is less than 63.5 cm (25 inches)
tall.
• Discontinue use of changer if infant can
push up on hands and knees or sit
unassisted.
• DO NOT carry changer with infant in it.
Changer can only be used when bassinet is
installed in Playard.
Triangular
Hole
T-Fitting
T-Slot
Triangular
Tab
Attachment
Strap
Triangular
Tab
T-Fitting