Filter
Top Products
HARNESS SYSTEM - removal and re-assembly
14
Removal:
Harness with Breast Plates:
• Remove harness strap loops from Splitter
Plates on back and bottom of car seat.
• Pull harness strap out of car seat.
NOTE: It is not necessary to remove
harness tie and tongues from harness
straps.
Store all parts for future use.
• Push buckle and crotch strap down into
crotch strap opening.
Harness without Breast Plates:
• Remove harness strap loops from Splitter
Plate on back of car seat.
• Pull harness strap out of car seat, harness
tie, and tongues.
Store all parts for future use.
• Push buckle and crotch strap down into
crotch strap opening.
Re-assembly:
When re-assembling harness system, be sure
harness straps are not twisted.
Harness with Breast Plates:
Thread Splitter Plate and looped end of
harness straps down through slots in seat pad,
under both Clips on bottom and slide harness
strap loop through Splitter Plate slot.
Harness without Breast Plates:
Thread end of harness strap down through slot
in seat pad, under both clips on bottom and
back up through slot in opposite side of
car seat pad, through harness tongues and
harness tie.
IMPORTANT: Harness strap MUST be threaded
over adjustment strap on bottom of car seat as
shown in illustrations.
Thread ends of harness straps through matching
slots in back of seat pad and car seat.
Re-attach harness straps to Splitter Plate on back:
Put right strap loop on Splitter Plate first, then
attach left strap loop.
Pull buckle out of of buckle slot.
1
3
4
5
2