Filter
Top Products
29
You MUST use locking clip provided with
car seat with a vehicle seat belt that slides
freely through the latch plate or the lap belt
cannot be tightly secured.
Install car seat and tighten vehicle seat belt.
Hold seat belts together at latch plate (fig. a)
then unbuckle.
Slide locking clip on seat belts approximately
1/2 inch (1 cm) away from latch plate.
Re-buckle seat belt.
1
2
3
4
1/2 inch (1 cm)
Avoid serious injury or death:
•Failure to use locking clip where
required will result in car seat not
being securely held in place.
•Remove locking clip from seat belts
when not being used with car seat.
•DO NOT use locking clip as a vehicle
seat belt shortener.
WARNING
5
F
Locking Clip
(fig. a)
VEHICLE SEAT BELTS (continued)
Test installation to see if car seat is secure.
If not secure, additional belt tightening may be
required:
• Unbuckle vehicle seat belt.
• Hold belts together and remove locking
clip.
• Shorten length of lap belt portion slightly
by pulling belt through latch plate.
• Re-attach locking clip.
• Buckle vehicle seat belt.
Press car seat further down into vehicle
seat cushion to help buckle vehicle seat belt.
Test installation to see if car seat is secure. If
not secure, repeat above steps until secure.