Filter
Top Products
OPERATIONS and ADJUSTMENTS (continued)
14
Changing Harness Strap Slots:
Harness straps must be through slots at or just
below shoulders.
A Loosen harness straps:
• Pull and hold upper belt tab.
• Pull harness straps out.
B Remove both harness strap loops from
Splitter Plate on back of car seat.
C Press Tab to release metal Rod and lift Rod
out of Pockets.
D Change harness strap slots.
Make sure harness straps are threaded
through matching slot of seat pad and
car seat.
It may be necessary to remove seat pad
from top of car seat.
E Re-install metal Rod:
• Lift harness straps up over car seat top.
• Slide metal Rod into side Pockets and
press Rod down below Tab.
IMPORTANT: Harness straps MUST be
behind metal Rod.
F Re-attach harness strap loops to Splitter
Plate (fig. e):
• Lower the harness straps down over
metal Rod as shown (fig. e).
• Put right strap loop on Splitter Plate
first, then attach left strap loop.
NOTE:
• Make sure both strap loops are securely
attached within Splitter Plate hook.
• Make sure straps are NOT twisted.
8