BT Digital Baby Monitor Plus Baby Monitor User Manual


 
Parent Unit
1. Plug the charger for the Parent Unit into the mains
power socket.
2. Remove the battery compartment cover and insert 2 x AA
rechargeable batteries into the battery compartment on
the Parent Unit and replace the battery compartment
cover as shown. You should always ensure you have
inserted batteries in the Parent Unit.
a.
b.
c.
3. Slot the Parent Unit into the charger. The red charging
light comes on and the icon begins to scroll whether
the Parent Unit is switched on or off. Charge the batteries
for 16 hours before switching on the Parent Unit.
4. For added convenience, attach the belt clip.
Parent Unit
1. Plug the charger for the Parent Unit into the mains
power socket.
2. Remove the battery compartment cover and insert 2 x AA
rechargeable batteries into the battery compartment on
the Parent Unit and replace the battery compartment
cover as shown. You should always ensure you have
inserted batteries in the Parent Unit.
a.
b.
c.
3. Slot the Parent Unit into the charger. The red charging
light comes on and the icon begins to scroll whether
the Parent Unit is switched on or off. Charge the batteries
for 16 hours before switching on the Parent Unit.
4. For added convenience, attach the belt clip.
BT Digital Baby Monitor Plus – Edition 4 – 26.02.04 – 5740
Setting up4
2
1
2
2
1
The parent unit will display
Not Linked
and the alarm will
sound until the Baby Unit is
switched on.
The Parent Unit can still be used
when it is in the charger.
Battery performance
The Parent Unit gives up to 16
hours continuous performance on
fully charged batteries.
The display shows the battery level:
Batteries are fully charged.
If the Parent Unit is on, this
icon will be displayed. If off,
the icon will not be displayed.
Up to 8 hours of use left
before the batteries will need
recharging.
Up to 15 minutes of use left
before the Parent Unit
becomes fully discharged.
Please note that new batteries do
not reach full capacity until they
have been in normal use for
several days. Running rechargeable
batteries right down at least once
a week will help them last as long
as possible.
Battery low warning
When the batteries are low
Battery low
is displayed and you
will hear a beep every minute.
Press any button on the Parent
Unit to stop the beeps
The charge capacity of rechargeable
batteries will reduce with time as
they wear out, so reducing the
performance time of the Parent
Unit. Eventually they will need to
be replaced. New batteries can be
obtained from the BT Baby
Monitor Helpline 08702 40 47 45.
WARNING
Never use non-rechargeable
batteries in your Parent Unit.
Use only the recommended type –
2 x AA rechargeable (1300mAh
NiMH) batteries – using other
types could permanently damage
your unit.
!
To remove the
belt clip
Push on the
belt clip tab
with your
thumb (1), then
lift the belt clip
off (2).
1