Filter
Top Products
Parent Unit
1. Plug the charger for the Parent Unit into the mains
power socket.
2. Remove the battery compartment cover and insert 2 x AA
rechargeable batteries into the battery compartment on
the Parent Unit and replace the battery compartment
cover as shown. You should always ensure you have
inserted batteries in the Parent Unit.
a.
b.
c.
3. Slot the Parent Unit into the charger, the red charging
light comes on. Charge the batteries for 16 hours before
switching on the Parent Unit.
4. For added convenience, attach the belt clip.
Setting up4
2
1
2
2
1
Battery performance
The Parent Unit gives up to 16
hours continuous performance on
fully charged batteries.
Please note however, that new
batteries do not reach full capacity
until they have been in normal use
for several days.
Running rechargeable batteries
right down at least once a week will
help them last as long as possible.
The charge capacity of rechargeable
batteries will reduce with time as
they wear out, so reducing the
performance time of the Parent
Unit. Eventually they will need to
be replaced. New batteries can be
obtained from the BT Baby
Monitor Helpline 08702 40 47 45.
Battery low warning
When the batteries are low you will
hear an alert warning tone every
minute at the Parent Unit and the
battery low light will come on.
To silence the alert, press any button
on the Parent Unit. You will have 15
minutes of use before the batteries
become completely discharged.
If the batteries are completely flat
the Parent Unit will switch off and
the link light on the Baby Unit will
turn red.
WARNING
Never use non-rechargeable
batteries in your Parent Unit.
Use only the recommended type –
2 x AA rechargeable (1300mAh
NiMH) batteries – using other
types could permanently damage
your unit.
The Parent Unit can still be used
when it is in the charger.
!
To remove the
belt clip
Push on the
belt clip tab
with your
thumb (1), then
lift the belt clip
off (2).
1