Filter
Top Products
1a 1b 1c 1d
2a 2b 2c 2d 2e
3a 3b
1e
2f
2g 2h
1 Adjusting the child seat
IMPORTANT – You must check
that the headrest is in the correct
position for your child before each
journey.
With the seat supported, squeeze
the headrest adjuster at the back of
the headrest (dia 1a).
Move the headrest up or down so
that the head is positioned centrally
as in the picture (dia 1b).
When the headrest is in the correct
position let go of the headrest
adjuster and ensure it has locked
into place.
To adjust the backrest, place one
hand on the seat section and push
firmly on the backrest until you
feel and hear a click (dia 1c). The
backrest will now pivot freely and
does not need to click into another
position.
Push the child seat back until it is
touching the car’s seat back (dia 1d).
The cars seat backrest can be moved
to a desired angle.
IMPORTANT – The backrest of
the child seat MUST always be in
contact with the cars seat back AND
the base section of the child seat
MUST always be in contact with the
car’s seat base.
If one or both sections of the child
seat are not in contact with both
sections of the car’s seat you MUST
angle the car seat more upright
(dia 1e).
IMPORTANT – Have you adjusted
the headrest to the correct position
for your child and ensured that the
seat has an appropriate recline angle?
IMPORTANT – You MUST NOT use
the child seat for a child weighing
more than 36kg.
Place the child seat forward facing in
your car, ensuring it is pushed firmly
into the car seat. Feed the diagonal
section of the seat belt through the
dark red upper belt guide on the
OPPOSITE side to the buckle (dia 2a).
IMPORTANT – When installing
the child seat, the vehicle seat
must be kept in a normal upright
position at all times. Reclining the
vehicle seat will adversely affect the
performance of the seat in a crash.
Fasten the seat belt across your child.
The lap section of the seat belt should
rest on the red lower belt guides on
each side of the child seat (dia 2b).
IMPORTANT – The lap section of
the seat belt should rest as forward
and as low as possible over your
child’s pelvis.
Remove as much slack as possible
from the seat belt and make sure it
is fitted comfortably, but tightly and
is not twisted (dia 2c).
IMPORTANT – You must use the
upper belt guide at all times.
IMPORTANT – Ensure that the
diagonal section of the belt lays over
the shoulder of the child and NOT
against the neck.
Tighten the seat belt by pulling the
diagonal section in the direction of
the arrow
(dia 2d).
If your vehicle has an adjustable seat
belt upper anchorage, adjust its
height so that the seat belt passes
through the centre of the upper belt
guide on the child seat and pull the
seat belt to tighten
.
IMPORTANT – The child seat must
not be installed in a position where
the seat belt anchorage point is level
with, or forward of, the upper belt
guide (dia 2e).
Correct buckle position
IMPORTANT – Once you have installed the child seat it is
important that you check the position of the seat belt buckle
to ensure a secure installation.
If the seat belt buckle looks like this then the seat belt buckle
position is correct (dia 2f).
If the seat belt buckle looks like this, where the buckle is being
pulled around the shell into the red lower belt guide (dia 2g),
try another seating position in the car.
IMPORTANT – Do not leave your child seat loose. Always
fasten the seat belt across the child seat when it is not being
used by your child to prevent the seat being hurled forward in
the event of an accident.
If the seat belt does not lie within the red lower belt guides
then the seat is not properly installed (dia 2h).
If you are in any doubt contact Customer Services on
01264 386034.
To release your child simply undo the seat belt.
3 Looking after the child seat
Removing the cover
Unhook the elastics which hold the main cover section in place
(dia 3a). The red spots show their location.
Unhook the elastic from the
hook at the front of the seat
(dia 3b).
Unhook the elastics which hold the headrest cover section in
place (dia 3c). The red spots show their location. The edges
of the headrest cover section can now be pulled away from
the seat.
Children weighing 15-36kg (approx 4-11 years)
3c 3d
Unhook the elastics from the
hooks on the underside of the
seat (dia 3c).
2 Installing the child seat in your car
IMPORTANT – This child seat MUST only be used with a lap and diagonal seat belt (approved to UN/ECE regulation no. 16 or equivalent standards).