Filter
Top Products
the black shock knobs
as shown in Fig. 7.
There is an opening mid
way up each side with
silver fabric on both ends
where the elastic cord is
exposed.
4. Locate the looped
ends of the elastic cord
where they come out of
the back flap of the
Weather Shield. Each
has a loop with a cord
lock. One side at a time,
attach the looped end of
the elastic cord around
the black shock knob (on
the same side as loop)
as shown in Fig. 7 (right
side shown).
The cord locks allow the
loop to be enlarged or
reduced thereby
adjusting the tension on
the cord.
5. The front of the
Weather Shield attaches
to the lower frame at the
nose of the stroller.
Position lower air scoop
so that it is centered left
to right over the nose of
the stroller. Now, hook
the elastic edge of the
shield under lip on the
nose of the stroller as
shown in Fig. 8.
6. Make sure the elastic
edge of the Weather
Shield is wrapped under
the frame tube at the
footwell area as shown
in Fig. 9.
After completion of
Weather Shield
installation, confirm back
vents are aligned with
space between top of
seat back and canopy
and opening is free of
obstruction (see Fig. 1).
7. To place your child in
the stroller, pull the front
of the Weather Shield off
the stroller then lift it up
and over the forward
edge of canopy (see Fig.
10). This will temporarily
hold the Weather Shield
out of your way while you
place your child into the
seat.
8. Once your child is
secured in the safety
harness (refer to your
stroller owners manual
for proper use of the
safety harness system),
release the Weather
Shield from canopy and
re-secure under the lip
on the stroller nose (see
Fig. 8).
Fig. 11 shows a Weather
Shield correctly installed.
CARE INSTRUCTIONS:
Hand wash cold, hang dry, do not dry clean or iron.
LIMITED WARRANTY:
BOB Trailers Inc. takes pride in its workmanship and
strives to manufacture the best products possible.
Therefore, we warranty the Revolution Weather Shield
against defects in material and workmanship subject to
the conditions listed below. Since no product is
indestructible, it does not cover defects attributable to or
resulting from normal wear, abuse or alteration.
.
The Revolution Weather Shield is warranted for one
year from the date of original purchase.
.
Warranty is only valid for the original purchaser.
.
Proof of purchase is required to exercise this warranty.
.
Labor and freight charges are not included.
.
Normal wear, neglect, abuse, accidents, improper use
are not covered by this warranty.
.
Warranty claims must be made through an authorized
dealer.
.
This warranty is limited to the repair or replacement of
the defective part. BOB shall in no event be responsible
for consequential or special damages.
.
This limited warranty is the only express or implied
warranty applicable to BOB. Any implied warranties,
including warranties of merchantability and fitness shall
be limited in scope and duration in accordance with
this limited warranty.
Fig. 8 Front attachment
Shield Elastic
Hooked Under Lip
Fig. 9 Elastic under frame
Fig. 10 Shield placed on
forward edge of canopy
Fig. 11 Shield correctly installed
Elastic Under
Black Knob
Loop Around
Black Knob
Fig. 7 Elastic under knob
Fig. 6 Shield placed on canopy
Seam Aligned
With Support
P2OMA05B