Filter
Top Products
below until tracking is satisfactory. Fig. 12 illustrates how to interpret
the results.
Reference convention: Left and right are described as viewed from
the operators frame of reference (behind the stroller). Example: The
swivel lockout knob is on the left side of the stroller.
Fine tune tracking of stroller is accomplished by using the tracking
adjustment knob shown in Fig. 13. If your stroller pulls to the left, turn
the knob counter-
clockwise 1/2 turn.
If your stroller pulls
to the right, turn the
knob clockwise 1/2
turn. Repeat Roll
test and adjustment
until the stroller rolls
straight.
8. PARKING
BRAKE: The
brake is a parking
brake, it prevents
the stroller from
moving while
loading and
unloading. The
parking brake is not
designed as a
stopping brake. Do
not use the brake to
slow or stop the
stroller. The brake
is intended to park
the stroller on flat
surfaces, not on
inclines. Never
leave your child in
the stroller unattended with or without the parking brake set!
To set the parking brake, press the brake bar down into the locked
position (Fig. 14) with your foot on the red foot pedal making sure
the locking pin fully engages the locking disk. To ensure the brake
is set properly, attempt to roll the stroller fore and aft after setting the
brake. If the stroller will not roll, the brake is set properly. To release
the parking brake, lift up on the red foot pedal with your foot until the
brake bar springs up into the fully unlocked position (Fig. 15).
9. SUN CANOPY: The stroller features a two position canopy. To
fully open the canopy, rotate the assembly forward until the fabric is
taut. The rear canopy flap should be freed from the Velcro to give
additional sun protection. To reduce the size of the sun canopy, pull
the canopy toward the handlebar. The additional fabric can be gathered
by pulling the canopy
drawstring (Fig. 1) and
securing the cord lock.
10. SEAT SAFETY
HARNESS:
Set parking brake before
placing child in stroller. To
secure your child in the
seat, put one shoulder
strap over each shoulder
and snap the male buckle
into the female receiver on
the crotch strap (Fig. 16).
Adjust shoulder straps to
be snug and secure (Fig.
17). Connect and adjust
the sternum strap (red), see Fig. 18.
WARNING: Never place passengers in the stroller without securing
them in the harness. Unrestrained passengers can affect the control
of the stroller.
Passenger weight limit - 70 lbs
(32 kg)
Passenger height limit - 44 in
(112 cm)
11. RECLINING SEAT:
Set parking brake before making
any seat adjustments. To recline
the seat, rotate the ladder lock
buckles (Fig. 19) forward thus
releasing the reclining straps. To
raise the seat, pull the reclining
strap loops until you obtain the
desired position. The seat back
can be adjusted to recline
anywhere between the fully upright
position and the fully reclined
position (Fig. 19 & 20).
12. SHOCK ABSORBERS:
The suspension system features
two shock positions to provide a
comfortable ride for kids of
different weights. The two
positions are shown in Fig. 2.
Position 1 is intended for
occupants up to 40 lbs. (18 kg),
while position 2 is intended for
occupants from 40 to 70 lbs. (18
to 32 kg) total. The stroller
features a metal shock bracket
with a sliding track and spring
loaded shock pin that
automatically locks in place when
it aligns with either of the two
shock positions. Shock position
adjustments should be made with
the stroller unloaded. The shocks
will lock into position 1 when
unfolding the stroller. To use the
stiffer shock position, move the
shock from position 1 to position
2 by depressing the shock release
button (Fig. 2) with one hand, and
with the other hand, lift slightly
and pull the shock backward.
When the shock pin is properly
aligned in position 2, the pin will
snap into place. Repeat this process for the second shock. To move
the shock from position 2 to position 1, reverse the above process for
both shocks.
13. FOLDING:
Remove child from stroller. Remove the contents of the Low Boy
cargo pouch, seat back and seat pockets. The shock absorbers must
be in position 1 (Fig. 2) before folding. Press both the right and left
handlebar release levers (Fig. 3), and fold the handlebar forward as
shown in Fig. 21. Locate the
frame release handle
underneath the seat (Fig.
22) and pull upwards
sharply. This will allow the
lower frame to fold
together, as shown in Fig.
23. The folded stroller can
be made even more
compact by removing the
front and rear wheels. The
front wheel is removed by
opening the front wheel quick
release and removing the wheel
(see section 5). The rear wheels are
removed by releasing the parking brake
(See section 8), and then opening the
rear wheel quick release (Fig. 4), and
pulling each wheel directly to the side.
The Wrist Safety Strap can be used to
keep the stroller in the folded position for
transport and storage. With the stroller
folded, loop the end of the wrist safety
strap around the handlebar and back to
the cross tube and fix the Velcro surfaces
together (Fig. 24).
14. TIRE PRESSURE:
IMPORTANT: Check tire pressure before
every use. Keep all tires inflated to pressure
specified on the rim (30 p.s.i.).
15. STROLLER CARE &
MAINTENANCE:
The fabric is 100%
polyester with a stain
resistant treatment
that makes cleanup
easy. Use a sponge
with a solution of mild
soap and lukewarm
water (maximum
temperature of 100 deg. F / 38 deg. C). Rinse thoroughly with clean
water to remove soap then air dry. Do not use detergent.
Regular maintenance should include: Verifying tire pressure, verifying
that all screws and fasteners are tight, and wiping parts clean with a
rag. To reduce the possibility of squeaks, periodically apply a small
amount of lubricant (Triflow, 3-in-one, or light sewing machine oil) to
the pivot axles and interior faces of the pivot brackets, as shown in
Fig. 25.
STORAGE: It is best
to store your stroller
indoors when it is not in
use. This will prolong its
attractive appearance.
Extended exposure to
the sun's ultraviolet rays
can fade and damage
the fabric, tires, and
plastic parts.
CARGO: The stroller
is equipped with two
small seat pockets for
your child, a seatback
pocket and a Low Boy
cargo pouch under the
stroller. Adding weight
to the seatback changes the center of gravity of the stroller, and
increases the possibility that it will tip over backwards. For this reason,
loads in the seatback pocket should never exceed two pounds (1 kg.).
Although the seatback is padded, it is important to remember that this
is what your child leans against. Never place sharp or injurious objects
into the seatback pocket. Maximum load for Low Boy is 10 lbs (4.5
kg).
LIMITED WARRANTY
BOB Trailers Inc. takes pride in its workmanship and strives to
manufacture the best products possible. Therefore, we warranty our
Revolution Strollers against defects in material and workmanship
subject to the conditions listed below. Since no product is indestructible,
it does not cover defects attributable to or resulting from normal wear,
abuse or alteration.
.
Frame is warranted for 5 years.
.
Components and fabric are warranted for one year.
.
Warranty is only valid for the original purchaser.
.
Proof of purchase is required to exercise this warranty.
.
Labor and freight charges are not included.
.
Normal wear, neglect, abuse, accidents, improper assembly or
maintenance, or the installation of parts or accessories not compatible
with the original intended use of the stroller, as sold, are not covered
by this Warranty.
.
Warranty claims must be made through an authorized dealer.
.
This warranty is limited to the repair or replacement of the defective
part. BOB shall in no event be responsible for consequential or
special damages.
.
This Limited Warranty is the only express or implied warranty
applicable to BOB. Any implied warranties, including warranties
of merchantability and fitness shall be limited in scope and duration
in accordance with this limited warranty.
STROLLER ACCESSORIES
BOB offers a complete line of accessories for your Revolution stroller.
Visit our website for full details, specs and images:
www.bobgear.com
HANDLEBAR CONSOLE
At your finger tips storage for two water bottles or drinks and other
small items. 4 Velcro straps for easy attachment.
WARM FUZZY
Warm Fuzzy Seat Insert -The ultimate in plushness & comfort. Thick,
polypropylene fleece will give you and your child a warm fuzzy!
WEATHER SHIELD
Your little one will be dry & comfortable in bad weather, strolling with
the BOB Weather Shield!
INFANT CAR SEAT ADAPTER
Allows quick attachment of leading brand infant car seats to your
stroller so you dont have to wait to take your infant on a stroll with
BOB! Once installed, easily folds with stroller.
SUN PROTECTOR
Reduces up to 65% of solar heat and glare as well as UVA/UVB rays.
Also protects children from brisk winds and flying insects.
Fig. 18 Connect sternum strap.
Sternum
Strap
Wrist
Strap
Velcro
Cross
Tube
Fig. 24 Secure stroller in folded position.
Handlebar
Shoulder
Strap
Fig. 17 Securely adjust shoulder straps.
BOB REVOLUTION OWNERS MANUAL
Apply Lubricant
to Axle
Apply Lubricant
to Interior Faces
of Bracket
Lubrication Points
Fig. 25
Fig. 15 Parking Brake - Unlocked position.
Brake Bar
(Unlocked Position)
Shoulder
Strap
Crotch
Strap
Buckle
Fig. 16 Place straps over shoulders
and secure to buckle.
MA0606
(800) 893-2447 www.bobgear.com email- info@bobgear.com
Phone: (208) 375-5171 Fax: (208) 375-5172, BOB Trailers, Inc. 5475 Gage St. Boise, Idaho 83706
Fig. 14 Parking Brake - Locked position.
Locking
Disk
Brake Bar
(Locked Position)
Locking
Pin
(Engaged)
Red Foot Pedal
Reclining
Strap
Loops
Fig. 20 Seat in fully reclined position.
Seat Reclining
Ladder Lock
Buckles
Fig. 19 Seat in fully upright position.
Stroller with handlebar folded.
Fig. 21
Frame
Release
Handle
Pull handle upwards
sharply to fold.
Fig. 22
Stroller in fully folded position.
Fig. 23