Filter
Top Products
Server Properties Configuration
38 Chapter 5 Manual Documentation Number: ESR90x-0508m
B&B Electronics Mfg Co Inc – 707 Dayton Rd - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics Ltd – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
• Default – When this mode is selected and the server is updated, it will
revert the server to its default configuration.
•
RS-232 – When this mode is selected and the server updated, the
selected serial port will become an RS-232 serial port on the server.
•
RS-422 – When this mode is selected and the server updated, the
selected serial port will become an RS-422 serial port on the server.
•
RS-485H – When this mode is selected and the server updated, the
selected serial port will become a two-wire, half-duplex RS-485 serial
port on the server.
•
RS-485F – When this mode is selected and the server updated, the
selected serial port will become a four-wire, full-duplex RS-485 serial
port on the server.
Connection At
When the Connection Mode field is set to Client or Client (no heartbeat),
this field becomes active, allowing the Serial Server (acting as a client) to
connect to the server either on
Power up or on Data Arrival (first character
arriving).
Max Connection
This field allows the user to configure the Serial Server to have up to eight
TCP connections.
Remote IP Address
This is a security feature activated by entering the IP address of the desired
client. The Serial Server will only communicate with the listed IP address
and all other requests for connection will be filtered out. The Serial Server
must be set up as a
TCP or UDP Server to use this feature. The default
setting is 255.255.255.255.
If
Paired Mode is not being used, do not change this setting until the
application has been tested and is communicating properly. Then activate the
address filtering feature.
N
N
o
o
t
t
e
e
:
:
Refer to Chapter 1 Paired Mode