Filter
Top Products
2.0/0608/HF
STEP 1: Unfold the STROLLER FRAME (A) making sure the locks on both sides snap together.
STEP 2: Insert the SHORT AXLE (B) through the FRONT WHEEL (C), and add one FRONT SPACER
(D) and one CAP (E) to each side.
STEPS 3 & 4: Slip the BUMPERS (F) onto the two front axle posts (note the proper position below!).
Push the CAPS (E) onto the front posts as far as they will go. Push the BUMPERS (F) onto the CAPS
(E). The parts “snap” and lock together when properly connected.
STEP 5: Insert the LONG AXLE (G) through the rear posts of the stroller frame. Add one SPACER (H)
to each end of the axle; then snap the REAR WHEELS (I) on (squeeze the latch open, slide the wheel
onto the axle, and release the latch). Gently tug the wheels to ensure they are connected properly.
STEP 6: Adjust the height of the handle by pressing the buttons on either side.
STEP 7: Lock the safety latches.
STEP 8: Fold the stroller by releasing the safety latch and pulling up on the two frame buckles located
on both sides of the stroller seat.
1.
2.
3.
4.
5.
6.
7.
8.
Page 3 of 3