Filter
Top Products
1.0/0309/HF
Page 3 of 3
PARTS INCLUDED:
(A) 2 x PLASTIC BRACKETS
(B) 1 x TOP TUBE WITH STRAPS
(C) 2 x LEG FRAMES
(D) 1 x SWING SEAT/CARRIER SEAT
STEP 2:
Insert the
LEG FRAMES (C)
into the holes on the ends of the
PLASTIC BRACKETS (A).
Be sure the frames are inserted
far enough to be tight and stable.
C
C
AA
STEP 1:
Fully insert the ends of the
TOP TUBE WITH STRAPS (B)
into the posts on the
PLASTIC BRACKETS (A).
AA
B
STEP 3:
Wrap the straps on the TOP TUBE (B)
around the handle of the
SWING SEAT/CARRIER SEAT (D)
and secure the straps together.
D
The Swing is now ready for play!
For use with dolls up to 20 inches (50 cm).
The SEAT can be removed and
reattached as needed to convert
the item from a swing to carrier seat.
The angle of the seat can be adjusted
by grasping the head and foot of the
seat and tilting it back and forth to the
desired position.
Seat harness can be buckled by threading the
free end of the strap through both of the
plastic loops (PHOTO 1). Then thread the end
of the strap back through only one of the
loops and pull tight (PHOTO 2).
PHOTO 1
PHOTO 2