Baby Trend PY81988 Baby Furniture User Manual


  Open as PDF
of 6
 
Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.
Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.
ASSEMBLY
9
10
ASSEMBLY
PARENT ORGANIZER ASSEMBLY
MOBILE ASSEMBLY
ATTENTION:
A crib mobile is intened for visual stimulation and is not intended to be grasped by the child.
If attached to the crib or playpen, remove when baby begins to push up on hands and
knees. If so designed, mount on wall or ceiling clearly out of a standing baby's reach.
Always attach all provided fasteners (strings, straps, clamps, etc.) tightly to a crib or
playpen according to the instructions. Check frequently.
DO NOT add additional strings and straps to attach to a crib or playpen.
DO NOT attach the Mobile with child in Playard or Bassinet.
(a)
(b)
(c)
(d)
(e)
Connect the Parent Organizer/Diaper Stacker to
the Playard by sliding the two (2) connecting clips
over an open portion of the top rail of the Playard.
(Fig. 18)
NOTE: The Parent Organizer/Diaper Stacker
can only be installed on open sides of the Playard
where the connecting clips can easily be attached
without interfering with other features.
(a)
(b)
Fig. 18
(c)
(a)
(b)
Fig. 19
Fig. 20
Fig. 21
Fig. 22
(d)
(e)
Contents:
(a) 1 Mobile Lower Arm
(b) 1 Mobile Arm Holder
(c) 1 Mobile Upper Curved Arm
(d) 1 Mobile Tri-shaped Arm
(e) 3 Toys (toys may vary)
1. Insert the Mobile Lower Arm (a) into the
Mobile Arm Holder (b) untill locked together
(Fig. 19).
2. Insert the Mobile Upper Curved Arm (c) into
the Mobile Lower Arm (a, b) until locked
together (Fig. 20).
3. Snap the Mobile Tri-shaped Arm (d) onto the
end of the Upper Curved Arm (a, b, c)
(Fig. 21). Connect each of the three Toys (e)
to the Mobile by threading the string into the
slot at the end of each arm.
4. Insert the bottom of the Mobile Arm into the
frame of the Playard (Fig. 22).
Diaper Stacker
 previous