Filter
Top Products
8
CONTENTS (Fig. 1):
1 Mobile lower arm
1 Mobile upper curved arm
1 Mobile tri-shaped arm
3 Toys
Always attach the mobile securely to the playard according to these
instruction. Check frequently.
1. Insert the Mobile upper curved arm into the Mobile lower arm until
locked together (Fig. 2)
2. Snap the Mobile tri-shaped arm onto the end of the upper curved arm
(Fig. 3). Connect each of the three toys to the mobile by threading the
string into the slot at the end of each arm.
3. Remove the screw through the battery compartment door, located on the
inside of the lower mobile arm. Insert two AA Batteries as shown in the
diagram (Fig. 4).
WARNING: Old and new batteries
should not be mixed. Alkaline, standard car-
bon-zinc, and rechargeable nickel-cadmium
batteries should not be mixed. Remove batter-
ies before storing mobile for a prolonged period
of time.
4. Insert the bottom of the lower mobile arm into the hole in the corner
tting of the play yard (Fig. 5). To remove the mobile, squeeze the two
plastic tabs that protrude through the bottom of the corner tting while
pulling upward. The mobile will rotate out of the way for ease in placing
or removing the baby from the bassinet.
WARNING: This mobile is designed
to be used from birth to 5 months. A mobile
is intended for visual stimulation and is not
intended to be touched by the child. Possible
entanglement injury: keep out of the babyʼs
reach. Do Not place your baby directly under
the mobile. Remove mobile from playard when
baby begins to push up on hands and knees.
WARNING: Do not add additional
strings or straps to attach to a crib or
playpen.
TO ASSEMBLE MOBILE
Figure 1.
Figure 2.
Figure 3.
Figure 4.
Figure 5.